The body thickness of the 29mm is also well suited for most people's palms. The grip is comfortable, but the height of the main unit is 91mm, which is slightly longer. It seems that Augvape VT EC1.8 has made some sacrifices in order to be loyal to the prototype.
Augvape VTEC1.8 integrated ignition button is also one of the highlights, making the mod more integrated, strong rebound, clear keystroke, hard to feel, but need to adapt when you just get started, because the finger will always adjust unconsciously next to the turntable.
There is no need to repeat the performance. The performance of the three output modes is gorgeous. The fancy coil used is 0.08Ω, and the 65W in the V mode is sufficient enough.
Regarding temperature control, what I have a desire to say is that Augvape VTEC1.8's choice is not unreasonable. After several years, the "addition" of vape equipment has been somewhat rampant. This is very similar to buying a car. The function may not be used in the future, but it should also be used for comparison, often overlooking the most fundamental function of the product itself.
Temperature control is also accompanied by vapes for two years. Although it is only a small amount of data written into the chip, it will not have much impact on the actual cost. Nevertheless, it will complicate the operation and setup, especially for novices.
If there is still no breakthrough in technology, it is impossible to form a complete set of equipment support. Maybe one day, the temperature control will completely withdraw from the historical stage of vapes, or that the real temperature control can become a new trend, it should be “temperature control suit.” The suit is armed with a special temperature-controlled atomizer, and specially designed temperature-controlled e-liquid, which is similar to today's "flat smoke."
Another point is that it is also a practical function to cancel the power decimal point. Because of the current large smoke environment, the power setting of 0. W is not make a much different. Even with the small suction aerator, the actual effect of 12W and 12.2W is almost unexpected. It only increases the time when users adjust it. This change has already appeared on some mods, which is an improvement for ordinary users.
In terms of appearance, the main paint surface is also relatively firm. If it is not intentionally damaged, there will be no paint stripping under normal use.However, the two corners at the bottom of the main unit will have a small area of wear due to friction with the table, which has little effect on the appearance.
Having said so many advantages, I also talked about some problems that Augvape VTEC1.8 found during use. The first problem is the new atomizer. When you replace the atomizer, the host will pop up the menu and move the dial up to confirm (equivalent to press the button +), the power setting will automatically change to 10W. This is not the recommended power that the chip automatically sets according to the resistance. Because all the different values of the atomizer will change back to 10W, it has to be reset, and the screen display The rest of the project will retain the previous settings and data, which is not very convenient for users with more atomizers.
In addition, there are Joules in V mode. I personally think that there is not much need. It is better to change the real-time output voltage. Although the hidden voltage has certain protection for the algorithm and operation mechanism, there is no secret in the vapes industry. If a feature is very popular with users, the next wave of mods in a few days will basically become popular.
Представленная на Форуме BelVaping информация предназначена только для совершеннолетних пользователей. Просматривая этот сайт, Вы подтверждаете, что достигли совершеннолетия в своей стране.