TAUREN's switch design is interesting. The battery contact part adopts a fixed design. The upper part of the switch is always in contact with the bottom of the battery. The button is connected with the steel ball. After pressing the button, the steel ball follows the button and goes up with the top contact. After the loop is formed, the current is turned on.

This kind of structure is relatively reliable, and it is also considered as a kind of “adaptive switch”. Since the contact is always in contact with the battery, the battery is firmly fixed in the mechanical rod while the switch is tightened, and does not shake.
When there is a tolerance in the interface of the battery or the atomizer 510, no user adjustment is needed, as long as the bottom switch is tightened. Of course, the force is appropriate, and it is tightened rather than locked.

The contact is removed, and under the insulating material is a magnetic ring composed of four magnets. This design allows the user to reliably complete the ignition when the switch is pressed at any position and angle to avoid the pinch of the switch.
The design of the ball is also a bright spot in the switch part. With the corresponding hemispherical slotting of the button and the contact part, the current can be stabilized, the contact area is increased, the internal resistance is reduced, and the arc can be avoided.
In the actual test, the hand of the switch is slightly softer, the key stroke is moderate, flexible and reliable, but when it is shaken, the ball in the switch will make a sound.
According to the official news of THC, in order to adapt to the user who likes the spring structure, the TAUREN mechanical rod will also be released with the version of the spring button for users to choose
This switch structure allows TAUREN to be compatible with both 21700 and 20700 batteries (18650 with conversion sleeve is equivalent to 21700). Because the contact of the switch cooperates with the 510 interface of the atomizer to clamp the battery, even if there is a gap of more than 1 mm between the 20700 battery and the tube wall, it will not shake.
TAUREN 510 interface straight through the mechanical rod, install the atomizer before installation, and then install the battery, the bottom switch is tightened and shake the shaft, no battery loose sound, no need to force too much to deliberately tighten, otherwise it will This causes the positive electrode at the top of the battery to sag.
Measured
I used the Drupa 24 RDA for testing. The data was a 3-core Clapton fancy coil with a detected resistance of 0.08 Ω.
The actual test results are very good, although the use of fancy coils, but TAUREN's ignition response is very fast, almost the same as pressing the switch, the coil began to burst out of smoke, and the performance of continuous output is also very good.
Sum Up
Since this TAUREN supports the 21700 battery, I have experienced it for a little longer. I just got the test sample when I shipped it. It was still 2017, and it is now 2018 when I sent the article...
Because I also have the same questions as vapers, I want to test more comprehensively:
● How does the 21700 battery perform on the mechanical pole?
● Does the 21700 perform better than the 20700?
● How long does the 21700 last longer than the 18650 battery?
● Is the 21700 mechanical rod as bulky as the 26650 mechanical rod?
After getting started for the first time, my view on the 21700 battery has changed. The performance improvement brought by the new battery is still obvious. The rapid burst of the fancy coil can show the advantage of the output of the 21700 battery. At full power, the fierce output of the first few mouths may even be mixed with a slight paste.
In terms of battery life, the 21700 also has a good performance. According to my frequency of use, from work to late night to sleep, if you use 18650 battery, 2 sections of light is definitely appropriate, but use TAUREN with 21700, 1 full power 21700 battery is enough, no spare battery debut Opportunity.
In addition to battery life, compared with the 18650 battery, I prefer the 21700 because the voltage (that is, the power) gradually decreases as the battery discharges. The 21700 does not have the "powerlessness" of the 18650, as long as you press the switch, any The taste and the amount of smoke will not disappoint you, and the 18650 will often be small and small, and there will be no smoke.
URL: https://www.vapeciga.com/products/thc-t ... anical-mod
Added in 1 minute 2 seconds:
TAUREN mechanical rods are currently available in red and brass. Each material is divided into two versions, black and pure copper. When purchasing, if you have experience in maintaining copper products or are willing to learn related knowledge, you can choose Pure copper version, if you do not like the effect of copper oxidation, I suggest to choose the black version, there is no difference in performance, the inner wall is copper, but the surface texture and process are different.
Added in 32 seconds:
Finally, the performance difference between the 21700 battery and the 18650 battery is quite obvious on the mechanical rod. If the cost of the new model battery can be further reduced, perhaps in 2018, the mechanical rod is the best for the new model battery. stage.
Added in 33 seconds:
Added in 14 seconds:







Представленная на Форуме BelVaping информация предназначена только для совершеннолетних пользователей. Просматривая этот сайт, Вы подтверждаете, что достигли совершеннолетия в своей стране.